Klark Teknik: DN100

The new Klark Teknik DN100 Direct Injection Box is the natural successor to the long-established LBB100.

A ground-up redesign provides an extended dynamic range, lower noise floor and all the world-class audio performance you’d expect from Klark Teknik. DN100 is also designed to handle the rigours of life on the road: a thick aluminium shell protects the electronics, and this in turn is protected by a tough silicone rubber casing, which is replaceable and available as a spare part.

We’ve also fitted a Kensington security slot in one of the end panels to allow the unit to be made secure using a Kensington MicroSaver security cable.

Attention to detail – it’s what makes a good unit into a great one.

Input
Type active electronic, balanced or unbalanced
Impedance 1M Ù nominal, balanced or unbalanced (jack connectors) 20K Ù (XLR input only)
Connectors 2 quarter inch jacks and 3-pin XLR linked in parallel Maxmum level 30dBu
Attenuator 30dB switchable

Output
Type Transformer Isolated, balanced
Impedance 300 Ù
Connector 3 pin XLR
Max. Level 10dBu with load >2k Ù
Min. load 600 Ù

Performance
Noise -100dBu, 20Hz to 20kHz unweighted, with input terminated by 10k resistor
Frequency response +0.5/-1dB 20Hz to 20kHz
Distortion (THD+N) output <0.01% @ 1kHz, +4dBu

Power Requirement Voltage +48V Phantom *
Current consumption <10mA

Weight <1kg

Dimensions Length 142mm (5.6 inch)
Width 106mm (4.2 inch)
Height 60mm (2.35 inch)

* The DN100 has been designed to allow use at phantom voltages less than +48V. The unit will function down to +20V (when used with 6k8 dropping resistors) but with reduced headroom and dynamic range. All the specifications above are quoted using standard +48V Phantom power.

This item ordered through eric lindsey music will be delivered by the UK Parcel Force courier '2 day delivery service'. In the unlikely event any of the the items within your order are not deemed fit for dispatch or are out of stock we will contact you as soon as possible with any changes to the dispatch date.